82 Degree Countersinks: HSS and Carbide, Made in USA

Why the 6-flute Chatterless design matters

A single-flute or three-flute countersink cuts intermittently: each edge enters, the tool deflects, the edge leaves, and the tool springs back. On a drill press or a hand drill that rebound becomes the faceted, chatter-marked seat every machinist has seen. Resonant vibration is the cause, and a tool with symmetrical cutting edges reinforces it.

Severance Chatterless Countersinks™ use a patented six-flute pattern with unequal spacing. At least two edges are in the cut at any moment, so the load-and-unload cycle behind chatter never starts, and the staggered spacing breaks up the harmonic. Each flute takes a smaller chip, which lowers radial load, spreads wear over six edges, and stops the grab in soft stock. The result is a smooth, burr-free 82° seat in interrupted cuts and difficult materials, at higher feed rates than a conventional countersink allows.

HSS or solid carbide

Both 6-flute series are made in 82°. The HSS tools are premium M2 high speed steel at Rc 63 to 65: tough enough for a hand drill or a drill press with quill play, easy to regrind on standard wheels, and the economical choice for low-carbon steel, nonferrous work, and any material under Rc 45.

The solid carbide tools are sintered by Severance in a tungsten-cobalt grade of 91.7 to 92.2 Rockwell A. Carbide runs at about twice the surface speed, often gives ten or more times the service life in hard or abrasive materials, and pays for itself on a rigid CNC where a tool change costs more than the tool. The catalog rule of thumb is carbide for production runs in cast iron, alloy steel, or glass-reinforced plastics. Carbide is brittle, so keep it off hand-held drills. The HSS vs carbide guide works through cost per hole.

Speeds and feeds

From the speed and feed page, a 1/2″ body HSS countersink runs 600 to 1,200 RPM in mild steel, 1,200 to 1,800 in aluminum, and 300 to 600 in stainless; carbide roughly doubles those. On CNC feed 0.001 to 0.003″ per revolution in steel and 0.002 to 0.005″ in aluminum, with a peck cycle on deep seats. For other sizes, RPM = SFM × 3.82 ÷ diameter, at 80 to 200 SFM for HSS countersinks and 200 to 400 for carbide.

Depth control

Depth by feel on a drill press wanders 0.005″ or more between holes, and seat depth sets the head height. A Stop-Countersink cutter in a Precision Stop Countersink Unit stops every hole at the same depth: the micrometer collar sets depth in 0.001″ steps and locks it, on a drill press or a hand power tool. Micrometer stop units also attach to standard countersink shanks, and on CNC the CNC-K series holds length tightly so a preset repeats.

Regrinding

Every tool on this page is resharpenable. Severance regrinds its own countersinks in HSS and carbide to the factory 82° geometry, with a standard 1-3 week turnaround and rush service available. Regrinding typically costs 25 to 40 percent of a new tool, and most tools can be reground 2 to 4 times. See the regrind service page for how to ship tools.